steering angle sensor callibration

[pecky]

I guess vauxhall need to read their own bulletins then
http://www.diagnostics.org.uk/help/s...ode-impossible

Has the steering wheel been off for any reason? Would be unusual for this to happen out of the blue.

Could happen if the car has had clutch or gearbox work as the steering collumn would be disconnected.

[cheekymonkey]

yes had the clutch replaced and the steering rack fell of the colloum

[pecky]

Assuming the steering angle sensor is back in the correct physical position, take the battery off as per the bulletin in the link

You need to be careful with an off position steering angle sensor as the ribbon cable in the CIM can snap which then means a new CIM is required.

[cheekymonkey]

does the car have to be drivan once the sensor has been recalebrated for the esp light to go out

[astrakyle]

Hi I have a very similar problem with the steering sensor, snapped ribbon during a clutch flywheel replacement changed ribbon but need to re-calibrate. can this be done WITHOUT a tech2 or whatever a garage may use? any help much appreciated

kyle

[assimoes]

I´m having the same problem. But my car went to change Timing belt.

Could the error been caused by this intervention?

[sourcerer]

Hi i have the same problem i even removed cim eprom and read it with programmer to make sure code is correct

thank you for the share