This device is wellcome when on highway and, why not, also on long and low-speed-limited country roads.
Abstract:
If your Corsa D has a Diesel engine or is ESP equipped you have high chances to have a prepared model.
However check if the steering column is wire connected to BCM with the appropiate wires:
Rotate the steering wheel 90 degrees clockwise or anti-clockwise and then remove the 2 caps over the screws (right and left side), then with a torx T20 remove the screws. Remove the plastic cover. The connector which we have to control is connected to the stalk of the turning signal.
So: the connector is on the rear of the turning signal stalk. Watch if there is it (it has a 2 pin connector) and if there are wires connected to.
If there are not so it is more difficult but not impossible: ask here if you want to have more informations.
What you need:
- Corsa D with Diesel Engine or ESP equipped model
- Torx T20
- Cruise Control Stalk (GM 13191079)
Procedure:
- Turn off the dash.
- After removing the plastic cover of the steering wheel (see above), use a thin screwdriver to unlock the stalk moving it in the slot. Do not pull hard, if you can’t move it so probably you should check better with the screwdriver.
- Place the new stalk sliding it inside an push until you hear a click. Connect the wires to the connector placed behind.
- With the ignition off, plug in Tech 2 and turn the ignition on.
- Program with the Tech2
-Remember ti check if it is selected your country (it is needed to set the cruise in kmh or mph)- Disconnect the Tech 2
- Place back the plastic cover of the steering wheel screwing the screws back (remember the caps )
FINISH
When you’re done you can check if the Cruise Contol fully works, but remember this:
In order to acrivate the Cruise Ccontrol you must press at least one time the brake pedal when engine on.
To deactivate it you can:
Press the brake pedal
Press the clutch pedal
Press the putton on the stalk
To activate it you have to:
Rotate up thes talk to assign current velocity
Rotate down to assign the previous stored velocity
To change cruise speed rotate up-down the stalk
Bookmarks