CIM SPS programming

[Miriada 4344]

Hi all
anyone can help, how to properly do the CIM software update (SPS programming)?
I did on body, CIM, additional functions, prepare SPS programming, (safe same date) ignition and tech2 on all time
All proces SPS from TIS, reprogramming finish 100% and after CIM did not want to answer any more.
what I did wrong?
THANKS

[soulman]

Not done a CIM on a Zaffy before..

I've seen it previously on the veccy where it automagically updates the code version though

[Miriada 4344]

Hi this I found on one of the forum.

Important: For a successful programming follow the instructions in TIS 2000 and set up the CIM for programming by Tech-2 before reprogram. Procedure for CIM SPS programming:

--> After selection of MY and Vehicle "Enter"
--> Body "Enter"
--> CIM "Enter"
--> Additional Funktions "Enter"
--> SPS programming set up "Enter" - CIM SPS programming will be performed
--> Exit

Afterwards carry out the CIM SPS programming (Old software version:
M: --.57; New software version: M: --.62).

Important: During the CIM set up ignore all "switch off ignition" messages, otherwise the programming of the CIM won´t be successful.

Note: Vehicles with PEPS are not affected and therefore it is not possible to program a CIM with PEPS.