bolt part number?

[skydiver]

Im looking at getting my hands on some half leather recaros, problem is one of the bolts holding in the rear backrest has knackered up so looks like im going to have to chop it or something to get it out so i need a replacement. Its one of the bolts on the single rear back rest at the back on the boot side. T50 head i think. Any ideas where i can get one from?? Dont wanna have to buy a full kit from vaux or owt daft just want 1 new bolt. May also have to re thread the hole

[G1NG3R]

Get it out mate and I'll match you one up from my garage at work got loads there

[skydiver]

thats the problem mate i cant get the damn thing out haha, just thinking ahead as ill need the part for next weekend when i go and puck the seats up, going to remove mine before hand, then when i get there fit the new ones straight in, but need the replacement bolt too. will try and get a photo of the 1 i mean.

[G1NG3R]

Ok I think I know what it's like anyways try an get a pic an ill get a few together at work and meet up wid ya in the week to give em ya matey

[skydiver]

cool, i only need the 1, as the others are ok, just when i had to remove the seats to seap the rear quarter cards over one bolt came about half way out and jammed on the thread probably rusty, then i ended up rounding the torx head on the bolt off, so its royally screwed really. where abouts are you located??

[G1NG3R]

Live in pensnett, an work in west bromwich, not too far from you, were bout wolvo u from ?

[skydiver]

im in the deep dark depth of bilston haha. rite on the main road. going out in a few so will get some pics and post up later. not sure what the thread size is on them though

[G1NG3R]

I'm from that end originally just off Bradley lane, by rocket. Pool,

[Toddyc]

Best way to get that out is if you've got a big flat head screwdriver, use a hacksaw cut a groove in and get it out that way or try hammering a socket over it that way you won't need to re-thread the hole

[skydiver]

thats what i was thinking, it screws out half way then jams solid. gonna cut the head off, and screw it through till it drops out, then just run a tap down the hole to clean the thread up ready for the new bolt.