how to enable Park pilot on corsa d with tech 2

[kadett90]

Yes,the back side of bcm.

[kadett90]

Was there pin in X11/39?

[wars1977]

Was there pin in X11/39?

Today I had little time. Sunday. Tomorrow I will know everything and write.

[wars1977]

Was there pin in X11/39?

I checked today whether I have a properly connected LIN cable from park to pin 1 in OBD. It turns out that yes and there is good electrical contact.

I do not know if connecting my LIN cable from the park to the BCM will change something. In the diagrams it is, after all, 1 wire bus and all LIN cables are together?

[kadett90]

It should work same in OBD pin 1.

[kadett90]

You still can't get connect to park pilot ecu.

[wars1977]

You still can't get connect to park pilot ecu.

I think so too. I'm a bit disgusted. A few wires, equipment in the mem workshop, how to do it also basically know. And it still does not work.

I noticed that when I first switched on the function ECU presence check module in Tech2, Tech2 stated that something changed on the CAN low speed bus, it looks like he found a parkpilot. I confirmed and asked if it was parkpilot. I confirmed that yes, then showed the list of drivers in the car to which parkpilot has to be reported so that they know that such a driver is in the car and communicate with it. I confirmed. The programming process in all controllers is completed successfully. At the end there was an attempt to connect with parkpilot and unfortunately there is no communication every time.

[wars1977]

You still can't get connect to park pilot ecu.

By the way, what software do you use? I'm asking for the screenshots you put in.

[kadett90]

When you measure between in park pilot connector pin 1 and 7 do you get 12V.

[wars1977]

When you measure between in park pilot connector pin 1 and 7 do you get 12V.

so when I measured between pin 1 and 7 I had 12v