clocks decode please

[sarah1331]

pecky can you tell me the code please so I can devorce and remarry to my car

thank you

https://mega.co.nz/#!zMxGWZqJ!ZLCTBU...SXHBAthKUCXgmY

[Mark I]

2608

Regards Mark

[sarah1331]

thanks buddy will try

[sarah1331]

pecky I have purchased

astra h sri clocks there not divorced can I program with opcom knowing the code or must they be reset

I also have some vxr clocks the same not divorced I am torn between vxr needle sweep (no glow plug teltale) and the sri ones , I need to swap as my clocks don't show cruse control that I have installed

[AndyM]

pecky I have purchased

astra h sri clocks there not divorced can I program with opcom knowing the code or must they be reset

I also have some vxr clocks the same not divorced I am torn between vxr needle sweep (no glow plug teltale) and the sri ones , I need to swap as my clocks don't show cruse control that I have installed

Was the cruise control programmed with OPCom? If so, then that may be the reason why the light doesn't show. I had this on my Zafira originally, as soon as I got Vauxcom, reprogrammed it and hey presto ... working.

[sarah1331]

Vauxcom is opcom

My clocks don't have the actual simble or the led for it

[AndyM]

Vauxcom is opcom

My clocks don't have the actual simble or the led for it

Yes, but most people are using an out of date chinese clone version that doesn't fully support cars.

Ah, OK ... I know a lot of people have problems getting the CC symbol to light up, as did I until I got the up to date Vauxcom.

[soulman]

thought of adding the led to the clocks where it doesnt light up plus the resistor it will probably need. I've looked into this on a set of vectra clocks that didnt have the ids+ led, followed the traces back to the chip and the chip is outputting 11v when commanded by 'telltale' test on tech2.. Maybe the same for you would work?

[Mark I]

pecky I have purchased

astra h sri clocks there not divorced can I program with opcom knowing the code or must they be reset

I also have some vxr clocks the same not divorced I am torn between vxr needle sweep (no glow plug teltale) and the sri ones , I need to swap as my clocks don't show cruse control that I have installed

Put the clocks in reset with the code, then program with your cars code. If it's a clone opcom I wouldn't like to comment on it ability to program the ipc, as I use tech 2 or the mdi but the genuine opcom/vauxcom should be able to.
If you use the vxr set the rev counter will also be wrong.
I have a spare set of diesel clocks with the needle sweep programmed.

Regards Mark

[sarah1331]

genuine opcom cannot do it

I put clocks in and use clock or my code it fails

if I reset my clocks first then instal new ones it fails on the code



can anyone devorce by dump??
can tech2 even devorce or is it like opcom must it be in original car