Hello again,
Its been a while, work commitments and snow! Lovely, no doubt you were hit with it alot worse up there mind....
Anyway thought I'd come back for your thoughts on this one!
So I had a friend (Auto Electrician who owes me a favour) put a crimp on some wire etc, using 0.5 thinwall and connected up to pin 38 of the X1, I crimped a PC header on the other end and connected to the switch.
On the other leg I connected up 0.5mm thinwall to switched live from Ciggy Illuminating live, also tried live from ciggy lighter & tried live to stereo...
So connected up and checked the status of clutch switch, on all three lives shows as inactive.
Started at the switch on all three feeds, multmeter shows 14v OK,
checked continuity from switch to X1 OK
checked X1 to UEC pin as advised OK
Bit stuck with it now, from what I've read this should get me where I want to be. my only thoughts are the cable but i cant see why...
can anyone help?
I'm near to writing off the whole thing and consider it an education!
Cheers
Lewis
Bookmarks