Maybe after connecting GND to pin 8 something went crazy?
I will check it tomorrow.
Type: Posts; User: wars1977
Maybe after connecting GND to pin 8 something went crazy?
I will check it tomorrow.
I had a connection yesterday like this.
1 - 12v
6 - Can Low (LIN)
7 - GND
8 - GND
So hella gutmman is a mistake ?! There is given pin8 as GND!
This is what the original parkpilot looks like with a sensor service only at the rear. The picture shows that only 3 LIN, GND and 12V cables come out of the 12p plug. How is it to pin 7 ??
2371
I cleaned it up
Unfortunately, I think that parkpilot is actually damaged. I will buy a second one, it is not expensive and I will check.
so when I measured between pin 1 and 7 I had 12v
By the way, what software do you use? I'm asking for the screenshots you put in.
I think so too. I'm a bit disgusted. A few wires, equipment in the mem workshop, how to do it also basically know. And it still does not work.
I noticed that when I first switched on the function...
I checked today whether I have a properly connected LIN cable from park to pin 1 in OBD. It turns out that yes and there is good electrical contact.
I do not know if connecting my LIN cable from...
Today I had little time. Sunday. Tomorrow I will know everything and write.
Hey, BCM back, on the other side?
Hay no gay sorry :)
Gay. My BCM
2366
Thank you very much for your time. Tomorrow I will check, but from what I remember, I could not find green wires at BCM, so I joined OBD.
I'll call you tomorrow. I missed something.
Thank you...
ok, so the blue plug 60 pin, pin 39?
If I understood it correctly, I will go to the workshop tomorrow, check it out.
Is this a 60 pin plug?
Sorry, I currently do not have access to the schematics.
Maybe some BCM picture, which plug?
Sorry, actually not under the radio, I'm connected under OBD pin 1. As you wrote. I connected it a few months ago and I just forgot, but as you wrote OBD I remembered immediately.
I connected to the green wire, gave my hand a cut that LIN was there. But probably I would have my hands now :). Ok where is it best to connect the communication cable?
I connected under LIN in the RADIO plugin, it was the easiest place for me.
Hey,
Thank you for the hint. In fact, pin7 connects to the mass of the parkpilota plate.
I was just in the workshop to check your suggestion. Ehh, unfortunately, no results.
No communication...
Hello,
In my Corsa GSi 1.6T 2008 there was no pilot park factory. There is also no bundle to him. Two plugs come to the parkpilot control unit itself. one 12 pin and the other 8 pin. To 8 pin...
Diagnostics.org.uk is a trading name of RJP Projects Ltd which is a company registered in England and Wales with company number 7453778