Search:

Try this dump

I use a UPA-USB persoanlly for all by eeprom reading. Was the first one I bought and I found a set of in-circuit leads for it too so it makes life simple.

For some clocks that may work.

This has some of them https://tech2.guru/eeprom-locations/

Yes it is the full software and web access for life.

Hi Gary,

Sorted the pricing and extended the offer.

With regards to unregister dump, I can possibly look at it, but don't make a purchasing decision on it appearing in the future.

Cheers,
...

Call it a Brexit deal, so keeping it until 23 March as a minimum:)

Hi,

As Soulman says, it cannot make dumps virgin in itself, but you have diagnostic tools to do it properly in vehicle.

2. I state 2 on the purchase, but providing it looks a genuine request I...

You need to check the canbus networks as well as it needs to be set present across all modules on that network.

It is on Low Speed Canbus I recall.

I've done very little works for around 10 months now, just not enough hours in the day.

Bluetooth came out in 2005, I know on occasion TIS will update the firmware, but it's that long since I did one I can't recall if it is 2004 or later screen, and then not all would update.

those photos don't show the important loom at the bottom of the pic.

yes the instructions do have an error

Sent from my SM-G950F using Tapatalk

yes, there is a retrofit kit whist adds usb. get it from opel or vauxhall. will need mdi to program and possibly a vci code.

Sent from my SM-G950F using Tapatalk

sorry guys, been stupidly busy with work. i'm off today and tomorrow so will go through the help desk when i get a chance.

Sent from my SM-G950F using Tapatalk

Hi,

It is confusing that status has been used on the first MoT and then the 2nd has no mention of the top mounting.

If the steering doesn't feel right either, then if I am honest, for the £29...

I'm not doing any looms at the moment.

Yes there is a blue lead between the 2, not available from vauxhall at all separately. The whole radio and display are wired completely differently, so the dash wiring needs sorting.

Then you are...

It could be a compatibility thing, also it may depend on if whoever did the sweep programming only changed the minimal amount of info necessary or went OTT with the changes.

Can't think of anything immediately if you have looked at the low speed can as well as the variant config.

With the opcom, just go to Infotainment -> Programming -> Code Index -> find 009 in the list on the left, the right hand side will confirm Astra H Linear Voltage and hit programme.

Job done.

I'm not doing any works at the moment, so I would chat to soulman about availability to help you fir and program.

They are all the same module on that age of car, so yes get a vectra one and get the code from the screen to pair. If the DAB hasn't been reset, that will need decoding as well.

Yes it does have a limiter, I had the same annoying thing happen occasionally on mine where it just refused to go louder.

I never bother with the mounting bracket, there is always somewhere to put it

Welcome along